Mobile Crossing WayPoint Map Loader Manual do Operador descarregar pdf (Página 86)

- Select the Datum you are using with the GP30; normally WGS84.

- Select the "Write Ozi" button to save these to an Ozi import/export file (Furuno DMX).

-SeaMarks can import this file (it is in the Furuno DMX format).

The option is in the Tools>Import Waypoints>Furuno DMX menu

Upload (to the GPS)

-------------------

- Create a file with SeaMarks and export the waypoints into Furuno DMX format.

- The Option is on the Tools>Export Waypoints>Furuno DMX menu

- In the Furuno software select the "Read Ozi" button to load the DMX file.

-You should see the waypoints in the window that look like the waypoints downloaded from the GPS. They look like:

$PFEC,GPwpl,2416.674,N,08130.002,E,4',NICE LEDGE ,A,,,,

- Select the "Write GP30" button to upload these waypoints to the GPS.

See the import/export section for additional information on naming conventions for Furuno and how to do the transfers

via a memory card.

Transfers to Furuno GP32, 33, 37, GP1650/1850

Navionics, Raychart 425, and Simrad CP31

The GP32 and similar units operate as masters in a master/slave communication. These GPSs can send to a PC by

themselves, but need some software in the PC to receive the data. They can communicate with SeaMarks with the

Download Furuno GP32 menu item. This brings up the NMEA communications page as shown below. You have to set

the model of the GPS and the COM port. See the early part of this chapter on setting the port if a serial to USB converter

has been employed. You might also have to set the Baud rate if it does not agree with your GPS's manual. Once

communications is established, you will see NMEA 183 sentences on the display. They are sent once per second, so

there should be plenty of action as seen in the figure below. If no activity is seen, press the Recycle Port button. That

should get it started if it is on the right port and at the right rate.

Downloading PC from GPS

From the GPS's viewpoint it is uploading to the PC. The basic idea is to set up the slave (PC) to accept the messages

from the GPS and then tell the master (GPS) to send waypoint list sentences instead of tracking sentences. You begin

by pushing the Start Receiving button that zeros the file length and instructs the program to only process the waypoint

list. That is, the once per second sentences will stop while the PC waits for waypoints.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 129 130

Sem comentários

Mobile Crossing WayPoint Map Loader Manual do Operador Página 86